ISO 6155 pdf download.Machine tools — Test conditions for horizontal spindle turret and single spindle automatic lathes — Testing of the accuracy
1 Scope
This International Standard describes, with reference to ISO 230-1 and ISO 230-2, geometric tests, machining tests and tests for accuracy and repeatability of numerically-controlled positioning axes on general purpose and normal accuracy turret and single spindle automatic lathes. It also specifies the applicable tolerances corresponding to the above-mentioned tests. This International Standard applies only to lathes with a multi-tool turret. This turret can be manually indexed, semi-automatically indexed by motion of the turret slide or automatically indexed by an independent control including numerical control. Lathes with sliding headstock are excluded from the scope, but lathes with numerical control are included as far as the contents of this International Standard are applicable. This International Standard deals only with the verification of accuracy of the machine. It does not apply to the operational testing of the machine (vibration, abnormal noise, stick-slip motion of components, etc.) nor to machine characteristics (such as speeds, feeds, etc.) as such checks are generally carried out before testing the accuracy.
2 Normative references
The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 68-1 :— 1 ) , ISO general purpose screw threads — Basic profile — Part 1 : Metric screw threads. ISO 230-1 :1 996, Test code for machine tools — Part 1 : Geometric accuracy of machines operating under no-load or finishing conditions. ISO 230-2:1 997, Test code for machine tools — Part 2: Determination of accuracy and repeatability of positioning of numerically controlled axes. ISO 1 1 01 :— 2) , Geometrical Product Specifications (GPS) — Geometrical tolerancing — Generalities, definitions, symbols, indication on drawings. ISO 3442:1 991 , Self-centring chucks for machine tools with two-piece jaws (tongue and groove type) — Sizes for interchangeability and acceptance test specifications.
All these types of lathe are manufactured with a variety of turret configurations. The most common types of configurations are designated types A, B, C (see figure 7) and D and are described below. Turret type A: Circular or multi-sided turret whose axis of rotation intersects the work spindle axis. Whether or not the turret axis is perpendicular to the work spindle axis, the axis of each turret bore must align with the work spindle axis in its working position. Tools may be located in the bore or recess, attached to the flat turret face or located and clamped in the bore itself. Turret type B: Multi-sided turret whose axis of rotation does not intersect the work spindle axis but is parallel or at a right angle to it. Special toolholders mounted and located on the turret sides (faces) are required. Turret type C: Circular (drum or disc type) turret whose axis of rotation is parallel to the work spindle axis. Tools are located in turret bores, which are parallel to the turret axis, and the turret axis is arranged so that the work spindle axis aligns with the axes of the turret bores in their working positions. Turret type D: Linear turret where tools are set on the cross slide. The necessary tool comes to the working position by the cross slide linear movement (see figure 6).