ISO 14946 pdf download

ISO 14946 pdf download.Small craft — Maximum load capacity 1 Scope This International Standard lists items to be included in the maximum load of small craft without exceeding the limits set by other ISO standards for stability, freeboard, flotation and crew. It further sets requirements for seating of crew members. This International Standard applies to small craft with a length of hull of up to in accordance with ISO 8666. Excluded are inflatable boats covered by ISO 61 85 and personal watercraft covered by ISO 1 3590. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards. ISO 8666:— 1 ) , Small craft — Principal data ISO 1 0240:1 995, Small craft — Owner’s manual ISO 1 221 7-1 :— 2) , Small craft — Stability and buoyancy assessment and categorization — Part 1 : Non-sailing boats of hull length greater than or equal to 6 m ISO 1 221 7-2:— 3) , Small craft — Stability and buoyancy assessment and categorization — Part 2: Sailing boats of hull length greater than or equal to 6 m ISO 1 221 7-3:— 4) , Small craft — Stability and buoyancy assessment and categorization — Part 3: Boats of hull length less than 6 m 3 Terms and definitions For the purposes of this International Standard, the following terms and definitions apply.3.2 seat any surface, horizontal or nearly horizontal, where a person may sit, with minimum dimensions of width by length (i.e. depth of the seat plus clear foot space in front of the seat) NOTE It is recommended that a width of be provided. 3.3 seating area clear sole space in an open boat or in a cockpit provided that an area measuring be available for each person so accommodated NOTE For dinghies in design category C and D, the deck area beside the cockpit may be used for this purpose. 5 Maximum load The term “maximum load” is to be...