ISO 14206 pdf download

ISO 14206 pdf download.Aerospace — Airframe ball bearings, single-row, rigid, sealed, light duty — Inch series 1 Scope This International Standard specifies the characteristics, boundary dimensions, tolerances, internal clearances and permissible loads of inch series, single-row, sealed, rigid, light duty, ball bearings used in airframe applications. These bearings are full complement (without cage) with a single row of balls and filling slot. These bearings are designed to withstand only slow rotations and oscillations under load and are intended for use between fixed and moving parts of an aircraft structure and their control surfaces. The airframe ball bearings covered by this International Standard are designed to operate in the temperature range of – 54 °C to + 1 50 °C. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 683-1 7:— 1 ) , Heat-treated steels, alloy steels and free-cutting steels — Part 1 7: Ball and roller bearing steels . ISO 1 1 32:1 980, Rolling bearings — Tolerances — Definitions . ISO 2082:1 986, Metallic coatings — Electroplated coatings of cadmium on iron or steel . ISO 4520:1 981 , Chromate conversion coatings on electroplated zinc and cadmium coatings . ISO 5593:1 997, Rolling bearings — Vocabulary . ISO 8075:1 985, Aerospace — Surface treatment of hardenable stainless steel parts . ISO 1 41 90:1 998, Aerospace — Airframe rolling bearings: ball and spherical roller bearings — Technical specification . AMS 241 7E:1 993, Plating, zinc-nickel alloy 3 Definitions For the purposes of this International Standard, the definitions given in ISO 5593 apply. 4 Symbols 4.1 For the purposes of this International Standard, the symbols given in ISO 1 1 32 apply. The symbols (except those for tolerances) shown in figure 1 and the values given in tables 1 and A.1 denote nominal dimensions unless specified otherwise. 4.2 Additional symbols for bearings covered by this International Standard are the following. C s permissible static radial load F a max permissible static axial load 5 Required characteristics 5.1 Dimensions — Tolerances — Internal clearances...