ISO 9152 pdf download

ISO 9152 pdf download.Aerospace — Bolts, with MJ threads, in titanium alloys, strength class 1 100 MPa — Procurement specification 1 Scope This International Standard specifies the characteristics and quality assurance requirements for MJ threads bolts made in titanium alloy, of strength class 1 1 00 MPa, for aerospace construction. It is applicable whenever it is referenced in a definition document. 2 Normative references The following normative documents contain provisions which, through reference in this text, constitute provisions of this International Standard. For dated references, subsequent amendments to, or revisions of, any of these publications do not apply. However, parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the normative documents indicated below. For undated references, the latest edition of the normative document referred to applies. Members of ISO and IEC maintain registers of currently valid International Standards. ISO 2859-1 :1 989, Sampling procedures for inspection by attributes — Part 1 : Sampling plans indexed by acceptable quality level (AQL) for lot-by-lot inspection . ISO 3452:1 984, Non-destructive testing — Penetrant inspection — General principles . ISO 4288:1 996, Geometrical Product Specifications (GPS) — Surface texture: Profile method — Rules and procedures for the assessment of surface texture . ISO 5855-2:1 988, Aerospace — MJ threads — Part 2: Limit dimensions for bolts and nuts . ISO 6892:1 998, Metallic materials — Tensile testing at ambient temperature . ISO 7870:1 993, Control charts — General guide and introduction . ISO 7961 :1 994, Aerospace — Bolts — Test methods . ISO 7966:1 993, Acceptance control charts . ISO 8258:1 991 , Shewhart control charts . ISO 9002:1 994, Quality systems — Model for quality assurance in production, installation and servicing . ISO/TR 1 3425:1 995, Guide for the selection of statistical methods in standardization and specification 3 Terms and definitions For the purposes of this International Standard, the following terms and definitions apply. 3.1 production batch quantity of finished bolts, manufactured using the same process, from a single material cast (single heat of alloy), having the same number of definition document, same thread and diameter code, heat treated together to the same specified conditions and produced as one continuous run 3.2 inspection lot quantity of bolts from a single production batch having the same number of definition document 3.3 definition document document specifying directly or indirectly all the...