ISO 5772 pdf download

ISO 5772 pdf download.Rubber hoses and hose assemblies for measured fuel dispensing — Specification 1 Scope This International Standard specifies the requirements for three types of rubber hose and hose assembly used for measured fuel dispensing, including oxygenated fuels (up to a maximum of 1 5 % oxygenated compounds). The three types of hose are as follows: a) type 1 : hoses with textile reinforcement suitable for reeling on a drum or hanging in bends; b) type 2: hoses with textile and helical wire reinforcement designed for torsional flexibility, suitable for coiling, reeling on a drum or hanging in bends; c) type 3: hoses with fine wire reinforcement designed for low dilation, suitable for reeling on a drum or hanging in bends. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid International Standards. ISO 37:1 994, Rubber, vulcanized or thermoplastic — Determination of tensile stress-strain properties. ISO 1 88:1 998, Rubber, vulcanized or thermoplastic — Accelerated ageing and heat-resistance tests. ISO 1 307:1 992, Rubber and plastics hoses for general-purpose industrial applications — Bore diameters and tolerances, and tolerances on length. ISO 1 402:1 994, Rubber and plastics hoses and hose assemblies — Hydrostatic testing. ISO 1 746:1 998, Rubber or plastics hoses and tubing — Bending tests. ISO 1 81 7:— 1 ) , Rubber, vulcanized — Determination of the effect of liquids. ISO 4649:1 985, Rubber — Determination of abrasion resistance using a rotating cylindrical drum device. ISO 4672:1 997, Rubber and plastics hoses — Sub-ambient temperature flexibility tests. ISO 6801 :1 983, Rubber or plastics hoses — Determination of volumetric expansion. ISO 7326:1 991 , Rubber and plastics hoses — Assessment of ozone resistance under static conditions. ISO 8031 :1 993, Rubber and plastics hoses and hose assemblies — Determination of electrical resistance. ISO 8033:1 991 , Rubber and plastics hose — Determination of adhesion between components. 3 Materials and construction The hose shall consist of the following: – a smooth, fuel-resistant lining of rubber or thermoplastic elastomer (TPE); – a suitable reinforcement; –...