ISO 5610 pdf download.Single-point tool holders for turning and copying, for indexable inserts — Dimensions
1 Scope
This International Standard specifies the general dimensions of turning and copying single-point tool holders for indexable inserts, and specifies preferred tool holders (see clause 5).
2 Normative reference
The following standard contains provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the edition indicated was valid. All standards are subject to revision, and parties to agreement based on this International Standard are encouraged to investigate the possibility of applying the most recent edition of the standard indicated below. Members of IEC and ISO maintain registers of currently valid International Standards.
ISO 3002-1 :1 982, Basic quantities in cutting and grinding — Part 1 : Geometry of the active part of cutting tools —General terms, reference systems, tool and working angles, chip breakers.
3 Remark
The designation of turning and copying tool holders is dealt with in ISO 5608; however, it should be noted that for preferred tool holders in accordance with clause 5, a dash replaces the letter symbol identifying tool length.
4 Dimensions
4.1 Shank
See figure 1 and table 1 .